TIG Welding Consumables: Tungsten, Collets And Gas Lenses Explained

Flap discs sit between cutting and grinding in terms of use, combining overlapping abrasive flaps to blend welds, remove coatings and finish surfaces with more control than a solid grinding disc. Every disc also carries a maximum operating speed printed on it by the manufacturer, and checking this against your angle grinder's rated speed is a basic habit worth building into every new batch you open.

Surface flatness and tolerance are the starting point, but fixturing is what turns a flat plate into a genuinely useful tool. Tables with a grid of holes or T-slots let you bolt down clamps, stops and jigs in repeatable positions, which speeds up repetitive fabrication and makes it far easier to hold parts square while tacking. A table without any fixturing options usually ends up needing extra clamps, magnets or improvised supports to achieve the same result.

If you're not sure which supply a particular machine needs or whether your workshop can support it, it's a sensible question to put to a supplier before ordering, and the team at welding tables can talk through the options against your existing set-up.

Most people buying their first welder get stuck at the same fork in the road: MIG, TIG or MMA. Each process strikes an arc differently and suits a different type of work, so the right choice depends more on what you'll be building than on which machine looks the most impressive on a shelf.

Space and power supply are the other two practical constraints worth checking early. Confirming that a chosen machine will run comfortably from the electrical supply actually available in the workshop, and that there's room to work safely around it with materials laid out, avoids the common mistake of buying a machine that then can't be used the way it was intended.

TIG welding relies on a handful of small consumable parts inside the torch that have an outsized effect on how the arc behaves. The tungsten electrode itself doesn't melt into the weld; it simply carries the arc, and different tungsten types, distinguished by their alloying elements, suit different current types and materials. Getting the wrong tungsten for the job typically shows up as arc wander or poor arc starts long before it shows up anywhere else.