Understanding Duty Cycle Before You Buy An Inverter Welder

Our own TP Weld Tables range is designed and manufactured in-house in Yorkshire, cut on a fibre laser for tight tolerances, which is the kind of detail worth asking about wherever you're sourcing a table, and you can see the full range via Tec Products Ltd.

Most people buying their first welder get stuck at the same fork in the road: MIG, TIG or MMA. Each process strikes an arc differently and suits a different type of work, so the right choice depends more on what you'll be building than on which machine looks the most impressive on a shelf.

Before choosing a machine, it's worth checking what your workshop's consumer unit and incoming supply can actually handle, not just what socket is nearest the bench. Buying a three-phase-only machine for a single-phase workshop, or underestimating the load a higher-output single-phase welder places on existing wiring, are both avoidable problems with a bit of checking upfront.

MIG (metal inert gas) welding feeds a continuous wire electrode through a gun, shielded by a gas supply, which makes it fast and relatively forgiving for general fabrication, sheet steel and repair work. Jasic's MIG range is one of the more popular starting points here, covering entry-level compact units through to higher-output machines as work scales up. TIG (tungsten inert gas) uses a non-consumable tungsten electrode with a separate filler rod, giving a slower but tidier result that's favoured for thinner materials, aluminium and stainless steel where finish quality matters. MMA, or stick welding, strikes an arc from a flux-coated electrode and needs no shielding gas at all, which makes it the most portable option and a common choice for outdoor or on-site work on thicker steel.

Welding produces fume made up of fine particulates and gases, and the composition varies depending on the process, the filler material and any coatings on the base metal. Fume rises from the arc and, without adequate control, can build up in the breathing zone of anyone working nearby, which is why extraction is treated as a core part of workshop set-up rather than an optional extra.

Duty cycle is one of the most misunderstood figures on a welder's spec sheet, yet it tells you more about real-world usability than the headline amperage does. It's expressed as a percentage over a ten-minute period at a given output, so a machine rated at 30% duty cycle at its maximum amperage can run for three minutes out of every ten at that setting before it needs to rest and cool.